retrohackers.org
http://retrohackers.org/

Photos of My MMC64 Case Mod
http://retrohackers.org/viewtopic.php?f=6&t=246		 Page 1 of 1
Author:  Schema [ Sat Apr 07, 2007 9:00 pm ]
Post subject:  Photos of My MMC64 Case Mod
Hi all,

I've put my MMC64 into a cartridge case to better protect it. 8) There's a slot for the SD card (obviously), a reset button and two DIP switches.

Image

Switch #1 is used to put the MMC64 into flash mode, so I don't have to open the case again and mess around with jumpers. (Switch #2 is not used.)

Image

Image

Here it is plugged into an SX64.
Image

And, a 64C.
Image

I will never use the clock port or cartridge passthrough, so they are hidden within the case. Yes, I had to remove the cart port connector (a very unpleasant process! :wink: ) But I think it's much nicer than having a bare circuit board, especially when carrying it around.
Author:  RaveGuru [ Sun Apr 08, 2007 12:01 pm ]
Post subject: 
Must say this is one of the nicest case mods for the MMC64 I've seen so far... Good job!
Author:  gklinger [ Sun Apr 08, 2007 5:28 pm ]
Post subject: 
I can't believe you didn't take a picture of the blue MMC64 inserted into the blue 64c. :)
Author:  zap [ Tue May 29, 2007 2:56 am ]
Post subject:  HMmm nice
Looks very factory 8)

Raised the bar a bit nice use of microswitch's instead of toggles.
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/