| retrohackers.org https://retrohackers.org/ |
|
| Logos for RR & MMC64 https://retrohackers.org/viewtopic.php?f=3&t=106 |
Page 1 of 1 |
| Author: | CrazyIcecap [ Sat Jun 10, 2006 8:38 pm ] |
| Post subject: | Logos for RR & MMC64 |
Hi ! I made some Logos for the RR and MMC64, and a friend told me it would be a good idea to upload them and post the links here 
RR-Logo: http://www.crazy-icecap.com/logo.jpg MMC64 full sized: http://www.crazy-icecap.com/mmc64-1.jpg MMC64 small (if you cut a hole in the case) http://www.crazy-icecap.com/mmc64-2.jpg |
|
| Author: | RaveGuru [ Sun Jun 11, 2006 10:37 pm ] |
| Post subject: | |
Nice! Keep up the work!! 
|
|
| Author: | CrazyIcecap [ Mon Jun 12, 2006 8:17 am ] |
| Post subject: | |
Thanks!
Here are some Pics with the Logos on the cases: 
|
|
| Author: | tnt/beyond force [ Mon Jun 12, 2006 11:23 am ] |
| Post subject: | |
 What did you use to cut MMC64 case? Soldering iron?
|
|
| Author: | CrazyIcecap [ Mon Jun 12, 2006 3:08 pm ] |
| Post subject: | |
No, but i tried to bend the case a little bit down, to cover most of the PCB...unfortunately it didn't work that well...new case, new try...
|
|
| Author: | tnt/beyond force [ Mon Jun 12, 2006 4:07 pm ] |
| Post subject: | |
CrazyIcecap wrote: i tried to bend the case a little bit down, to cover most of the PCB
What about cutting the top cover further away from external cartidge connector, then glueing end of cut-away part to top? Label would hide most of the seam, and if you are lucky you can cut parts along existing groove to make the rest less obvious. |
|
| Author: | paulm [ Mon Jun 12, 2006 9:09 pm ] |
| Post subject: | like the cover |
ya im going to rip the covers off my action replay 7 and 4 and build that now thats the nuts lol :lol: |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|
